- Step 1
Gather your supplies. At the end of the gallery, you will find a pattern that you can print.
- Step 2
Cut your pattern along the black lines. Leave the white area on the right eye uncut.
- Step 3
Place the pattern over the felt and cut out the pieces.
- Step 4
To cut out the center of the right eye, it's easiest to fold the eye over and cut a tiny slit in the center. Then you can cut out an almond shape.
- Step 5
You'll notice the pattern does not include the gray staples. This part is really simple. Just cut length-wise down your gray felt. The felt is just a tiny bit longer than the bag, so you will need little trimming.
- Step 6
Cut out a thick gray bar, about 2x the size of your previous piece of felt. Cut little bars, about half an inch wide, from this piece.
- Step 7
Place the pieces on the tote bag to get a good idea of where you will need to glue them.
- Step 8
Place a piece of wax paper inside the bag. This will keep any glue that may leak through from getting on the other side of the bag.
- Step 9
Begin to glue the pieces that go on top of each other together.
- Step 10
When your parts are done, glue them down to the bag.
- Step 11
If you have any excess, trim it off.
- Step 12
Let the glue dry and you're done! Check out more cool crafts at World of WarCrafts.
- A gift from the embalmer
A picture of the bag in use.
Right click on the pattern and save. Be sure to set your printer to landscape when printing.